Connect the computer to the AP with an Ethernet cable. Configuration on Repeater (TL-WA701ND V2/TL-WA801ND V2 and TL-WA901ND): Step 1.Wireless Network Name/Local Wireless Name - The SSID of the AP How to hard reset TP-Link wireless access points Wireless Name of Root (Remote) AP - The SSID of the Root (Remote) AP. Disable means the wireless radio has been turned off. Operation Mode - Indicates the mode which the AP is working on. TL-WA701ND V2, TL-WA801ND V2/V3, TL-WA901ND V3/ You can configure them in the Wireless -> Wireless Settings page. Dann kÃ¶nnen Sie die Taste loslassen und warten, bis der Access Point neu gestartet wurde. 5 bis 8 Sekunden die Reset-Taste, wÃ¤hrend der Access Point eingeschaltet ist. So try more times Betroffene Produkte: TL-WA701ND, TL-WA801ND, TL-WA901ND. In router mode you can only access it via wireless method. Your device is a V3 version, right? You can see the UG of page number 3 that the system led blinking means unit working normally: The reason why you can't access it is because the Ethernet port is a WAN port. Directly press and hold the reset button on the rear panel with a solid pin for approximately 1 to 2 seconds when the device is powered on.ï»¿ If you can see all the lights flashing, then go off and some lights go back on slowly, that means the device has been reset successfully.ï».You can hard reset your TL-WA901ND v4.x with ways bellow Use web interface : Open a browser and navigate to the web interface of the router (see default settings below) In the menu look for System tools and under there find the Factory defaults optio.TP link TL WA901ND 300Mbps access point Reset or Change setting TP Link N300 Tl WA850RE WiFi Network Extender Repeater unboxing.Home TP Link TL WA901ND reset TP link TL WA901ND 300Mbps access point Reset or Change

Tp link n450 manual